200 Output 380mm Stroke Hydraulic Pipe Bender for 22-108mm Conduit and Hydraulic Tube Bender

The SWG-4 is a hydraulic pipe bender used to form accurate bends in conduit and pipe during power line construction and substation installation. It develops a 200 output with a 380mm stroke and bends conduit from 22mm to 108mm in diameter with a wall thickness of 2.5-6mm, through angles between 90 and 180 degrees. The bending angle is set on the tool so each piece repeats evenly without re-measuring.

• 200 Output, 380mm Stroke: forms full-width bends in conduit up to 108mm in diameter.
• Direct Angle Setting: bends repeat evenly between 90 and 180 degrees without re-measuring.
• Forged Bending Arms: reinforced frame and hydraulic cylinder hold alignment under load.
• Quick-Change Dies: switch between pipe diameters quickly for mixed work.
• Safety Relief System: automatic pressure relief and non-slip handles protect the operator.

• Conduit bending for underground cable installation
• Transmission line pipe installation
• Substation piping modification
• Emergency repair and replacement work

• Produced under an ISO 9001 certified quality management system
• Work methods aligned with OSHA equipment standards
• Factory function and pressure testing before packing

• OEM and custom die configurations available
• Technical guidance on die selection and pipe bending
• Spare parts and after-sales support

• Minimum order quantity: 1 piece
• Price: negotiable depending on configuration and quantity
• Packaging: plywood case for export

To confirm a specification, request a quotation or discuss a custom configuration, contact our engineering sales team with your pipe diameter, wall thickness and required bend angle.